Microduino NRF Wireless Gateway based on Enc Gateway -304 KIT
Language | English |
---|
OutlineProject:Microduino-NRF Wireless Communication Based on Microduino-Enc Gateway Objective:To set up a network with Microduino-Enc, PC and router,using Microduino-NRF to control the LED in the LAN. Difficulty:Elementary Time-consuming:Two-hour Maker:Microduino Studio-YLB | |||||||||||||||||||||||||||||
Bill of Materials
| |||||||||||||||||||||||||||||
Document | |||||||||||||||||||||||||||||
DebuggingStep 1:Build the hardware Master machine control: Equipment:Microduino-Core+, Microduino Duo-V, Microduino-Enc, Microduino-nRF24, Router and network cables. Slave machine control: Equipment:Microduino-Core, Microduino-nRF24 and Microduino-FT232R | |||||||||||||||||||||||||||||
Step 2: Router network Power the router and connect the PC to network. Step 3: Download the program Start Arduino IED, open the Microduino example program and choose "Microduino Core +(Atmega644P@16M,5V)" as the board of the master machine and "Microduino Core (Atmega328P@16M,5V)" as the board of the slave machine, then download directly. Step 4: Control the LED in the LAN Open a new webpage, enter your IP address and you'll enter the control interface if you can connect the network successfully. | |||||||||||||||||||||||||||||
ResultAfter download, Microduino core accessed the network, then open the gateway, click button on control interface to control the corresponding node led, each time you press the button, the led will have a state transition. Because it is a node control, so only the node that slave program seted can be controled by the gateway control interface's node. | |||||||||||||||||||||||||||||
Note
Video |