Microduino Update light intensity to Yeeklink(TSL2561)

Language	English

Objective This tutorial will teach you update the light intensity's data to yeelink, using the light intensity sensor TSL2561. Equipment Microduino-Core Microduino-FT232R Microduino-Weatherstation Microduino-RJ45 Microduino-ENC28J60 Other equipment USB cable Ethernet cable Experiment Schematic 文件:Microduino光照强度上传到Yeelink(TSL2561)原理图.jpg 600px Microduino-RJ45 Microduino-ENC28J60 Microduino-Core Microduino-FT232R Microduino-Weatherstation Stack all of them, and then connect the ethernet cable. Program Refers to yeelink_TSL2561 Debug Step 1：Set up hardware, as follows: 文件:Microduino光照强度上传到Yeelink(TSL2561)连接图.jpg 600px Step 2：Add a sensor, one device can add more sensors, click [+ add a sensor] in [Device management], then you can see following picture: 文件:Yeelink添加光照传感器.jpg 600px At this point, you can see the data curve in [Device management], URL's address: http://api.yeelink.net/v1.0/device/4444/sensor/77777datapoints The number behind "Device" is your device ID, the number behind "sensor" is your sensor ID, every user has different ID. Step 3：Modify the API KEY, deviceID and sensorID to your own ID in code, and copy to IDE. Step 4：Make up connection and run program. Step 5：Then you can see the IP address and data information in serial monitor window, as following picture: 文件:连接到yeelink串口显示信息(TSL2561).jpg 600px At last, you can check the data in yeelink. Result In device management, your light intensity sensor will be show as following. If there is a value, that means successed. 文件:Yeelink光照传感器数据(TSL2561).jpg 600px Video http://v.youku.com/v_show/id_XNjk4NDMxNDg0.html