Microduino Enc Wired network experiment -302KIT

Language	English

Outline Project: Microduino-Enc Wired Networking Experiment Objective：Enable Microduihno-Core to connect with the network via Microduino-Enc and Microduino-RJ45, control four LED lights inside the LAN and achieve network control. Difficulty：Elementary Time-consuming：One hour Maker：Microduino Studio-YLB

Bill of Materials Microduino equipment： Module Number Function Microduino-Core(Microduino Core+) 1 Served as the slave machine,receiving and controlling signal Microduino FT232R 1 For program download Microduino Enc(Microduino Rj45) 2 For wireless communication Other equipment： Router one Network cable one micro USB cable one LED Four Bread board one Breadboard jumper one box 文件:302KIT-module1.jpg 302KIT-module

Document

Debugging Step 1：Set up router network Power the router and connect the PC to network. Step 2： Build the hardware Install all Microduino modules needed and adopt the extension board Microduino Duo-V for easy debugging.

文件:302KIT-module2.jpg 302KIT-module 文件:302KIT-system.jpg 302KIT-system

Step 3： Download program Start Arduino IED, open the Microduino example program and choose the board "Microduino Core (Atmega328P@16M,5V)", then download directly. Step 4：Connect the network Connect Microduino-RJ45 to the LAN port of router. Step 5：Wired control of the LED lights inside the LAN Open a new page and enter the "myip" address in the program.You can only enter the control interface when Microduino connects the internet successfully. Otherwise, it can not be opened.

Myip

Result Connect the Microduino core to network, control the LED by the button on web page. Press button, LED light, then press again, LED off.

Note Microduino Enc must be used with Microduino RJ45 together. Need configure the MAC address and ip address in local network. Video http://v.youku.com/v_show/id_XNjY1Njg5Nzcy.html