Wifi.joinAP()

wifi.joinAP(SSID, PASSWORD) 描述 设置wifi模块为Station 模式，这样作为终端设备联网。 创建库时需要调用#include <ESP8266.h>头文件。 参数 SSID：wifi名字 PASSWORD：wifi密码 实例 注意wifi名字和密码大小写 #include <ESP8266.h> #ifdef ESP32 #error "This code is not recommended to run on the ESP32 platform! Please check your Tools->Board setting." #endif /** **CoreUSB UART Port: [Serial1] [D0,D1] **Core+ UART Port: [Serial1] [D2,D3] **/ #if defined(__AVR_ATmega32U4__) || defined(__AVR_ATmega1284P__) || defined (__AVR_ATmega644P__) || defined(__AVR_ATmega128RFA1__) #define EspSerial Serial1 #define UARTSPEED 115200 #endif /** **Core UART Port: [SoftSerial] [D2,D3] **/ #if defined (__AVR_ATmega168__) || defined (__AVR_ATmega328__) || defined (__AVR_ATmega328P__) #include <SoftwareSerial.h> SoftwareSerial mySerial(2, 3); /* RX:D2, TX:D3 */ #define EspSerial mySerial #define UARTSPEED 9600 #endif #define SSID "wifi名字" #define PASSWORD "wifi密码" ESP8266 wifi(&EspSerial); void setup(void) { Serial.begin(115200); while (!Serial); // wait for Leonardo enumeration, others continue immediately Serial.print(F("setup begin\r\n")); delay(100); WifiInit(EspSerial, UARTSPEED); Serial.print(F("FW Version: ")); Serial.println(wifi.getVersion().c_str()); if (wifi.setOprToStation()) { Serial.print(F("to station ok\r\n")); } else { Serial.print(F("to station err\r\n")); } if (wifi.joinAP(SSID, PASSWORD)) { Serial.print(F("Join AP success\r\n")); Serial.print(F("IP: ")); Serial.println(wifi.getLocalIP().c_str()); } else { Serial.print(F("Join AP failure\r\n")); } Serial.print(F("setup end\r\n")); } void loop(void) { }

返回mCookie-WiFi界面