Microduino BLE Android-202KIT

Language	English

Outline Project：Microduino BT communicates with Android device Objective：Android mobile send the character to Microduino-Core and Microduino BT and display on OLED. Difficulty：Elementary Time-consuming：30mins Maker：Microduino Studio-YLB

Bill of Materials Microduino device Module Number Function Microduino-Core 1 core module Microduino-FT232R 1 Download program Microduino-BT 1 BT communication Microduino-S1 1 Connect the OLED Microduino-OLED 1 Display

文件:Android-202KIT-module.jpg 202KIT图片

Software Arduino IDE (1.0 release and upper), Downlaod 4.0 BT Android assistant：http://www.jnhuamao.cn/download.asp?page=2&ID=0； Other equipment Android device support BT 4.0, the OS should be 4.3 upper. micro usb cable. Document Download test program: https://github.com/Microduino/Microduino_Tutorials/tree/master/Microduino_KIT/kit_android_BT

Debug

Step 1：Start Arduino IED, open the test program, select the board "Microduino Core (Atmega328P@16M,5V)";

文件:Ble-Download.jpg Download OLED interface when download success. 文件:BlE-OLED-success.jpg OLED Step 2：After finished download program, power off, then plug in all module.

文件:202KIT-android-system.jpg 202KIT-OK Step 3：Set Android device, start Android device's BT function; Step 4：Open the BLE assistant; 文件:202KIT-ble-serial.jpg 202KIT-OK Step 5：Click the "search device", you can find the Microduino BT device; 文件:202KIT-ble-serial2.jpg 202KIT-OK Step 6：Click the searched equipment to match connection, mobile phone will prompte the connection process

文件:202KIT-ble-Connection.jpg Connection Connect successed, LED will light.

文件:Android-BlE-LED.jpg LED Step 7: Enter any text in the text input box, and then click send, you can see the sent text on the OLED (English characters). 文件:BlE-OLED.jpg OLED Send "clean" to clear the data on OLED. 文件:BlE-android-clean.jpg OLED

Result Microduino Core module and Android mobile can set up connection easily by Microduino BT module. Note Set the serial baud rate to 9600. If use the default jumper (RX0,TX1)，when download the program, need plug out the Microduino BT4.0 module. After finished download, then power off to plug in again. If changed the jumper, need to change serial connection of Microduino BT4.0 and Core module, the origianl connection is TX-RX0, RX-TX1, need change to following connection： TX-D2, RX-D3 (Corresponding to Core+'s Serial1) TX-D9, RX-D10 (invoke the SoftwareSeria library to resolve this issue) Video http://v.youku.com/v_show/id_XNjk0MTMyMzc2.html