Microduino Hall sensor to measure DC motor RPM

Language	English

Objective This lesson will teach you use the hall sensor to measure the RPM(Revolution(s) Per Minute) of DC motor, and display the value on OLED. Equipment Microduino-Core Microduino-FT232R Microduino-OLED Microduino-Cube-S1 Other equipment USB cable one Breadboard Jumper one box NPN triode one Breadboard one 2.2kΩ registor one 220Ω registor one Diode one Hall sensor one DC motor one Potentiometer one Schematic 文件:Microduino霍尔传感器测量电机RPM原理图.jpg 600px Program https://github.com/Microduino/Microduino_Tutorials/tree/master/Microduino_Sensor/HallSensorSpeedMeasurement Function description： attachInterrupt(0, rpm, RISING); //Bind the interrupt to pin 0 which corresponding to port D2 in microduino. When interrupt happened, invoke function rpm(), the trigger condition is that voltage changed from low to high. sei(); //Enable the interrupt cli(); //Disable the interrupt Debug Step 1：Copy the code to IDE and compile it. Step 2：Set up circuit, as follows: 文件:Microduino霍尔传感器测量电机RPM连接图.jpg 600px Note： 1：Duing setting up circuit, we will use Microduino-Cube-S1 board. This extension board was designed for OLED, only need plug in the Microduino-Core and Microduino-FT232R to slot and then connect the OLED to corresponding slot on Microduino-Cube-S1. 2：As far as possible close hall sensor to DB motor, and easy to detect magnetic field changes. Step 3：Run program. Step 4：Rotate the potentiometer, observe the value on OLED. Result Rotate the potentiometer, motor will rotate. Hall sensor will induct motor's magnetic field changes regularly, to determine the frequency in one second and calculate the RPM, and then displayed on the OLED. Video http://v.youku.com/v_show/id_XNjkyNzk0MTQw.html