Microduino Enc Wired network experiment -302KIT

Language	English

Outline Project：Microduino Enc Wire Network Experiment Objective：Use the Microduino Enc module to connect the Microduino RJ45 and Microduino core. In local network to control 4 LEDs and achive network control. Difficulty：Elementary Time-consuming：One hour Maker：Microduino Studio-YLB

Bill of Materials Microduino equipment： Module Number Function Microduino-Core(Microduino Core+) 1 Slave, receive control signal Microduino FT232R 1 Download program Microduino Enc(Microduino Rj45) 2 Wireless communication Other equipment： Router one Network cable one micro usb data cable one LED Four Bread board one Breadboard jumper one box 文件:302KIT-module1.jpg 302KIT-module

Document

Debugging Step 1：Set up router network Power on router, and connect the PC to network. Step 2：Set up hardware Install all Microduino module, use the extension board Microduino Duo-V for easy debugging.

文件:302KIT-module2.jpg 302KIT-module 文件:302KIT-system.jpg 302KIT-system

Step 3：Downlaod program Start Arduino IED, open the Microduino example program, board type choose "Microduino Core (Atmega328P@16M,5V)", download directly. Step 4：Connect the network cable Connect the microduino RJ45 to LAN port of router. Step 5：Control the LED in loacal network Open a new web page, enter into the address "myip". Microduiono networking success can enter the control interface, or can not be opened.

Myip

Result Connect the Microduino core to network, control the LED by the button on web page. Press button, LED light, then press again, LED off.

Note Microduino Enc must be used with Microduino RJ45 together. Need configure the MAC address and ip address in local network. Video http://v.youku.com/v_show/id_XNjY1Njg5Nzcy.html