Microduino-Moisture

Language	English

Microduino-Moisture Microduino-Moisture is a soil humidity detection sensor. Features Resistance-type humidity sensitive component with high sensitivity; Low consumption and high stability; Output: 0~5V analog signal Specification Operation voltage: 3.0V~5.5V 1.27mm-pitch 4PIN interface; Pin description: GND, VCC, signal input and NC(empty). Since the input signal is simulated, it needs analog interface to detect (A0~A7), which can be connected the pins (10,1,12) of the Sensorhub with the corresponding pins(A6,A2,A0). 文件:Microduino-Moisture rule1.jpg 600px Document Schematic: 文件:Microduino Moisture.Zip Development microduino-Moisture can be applied in soil humidity detection of the potted plant, agricultural irrigation and soil erosion. Application All hardware needed: Microduino-Core, Microduino-USBTTL, Microduino-sensorhub, a USB cable and wires; Software:　　 Make sure you build Microduino IDE. If not, please refer to: Microduino Getting start Stack all modules and connect the Moisture module to A0 port of Sensorhub with a wire. Open Arduino IDE, select File→Examples→Basics→ReadAnalogVoltage program examples, choose the right board from Tools→Board and then compile. Select the right port from Tools→Serial Port in Arduino IDE after compiling, then download program. After download, you can open the serial monitor and tell soil humidity from the displayed value, which is "0.00" when the Moisture sensor doesn't touch any object and will become bigger than 0" when touching the soil. Purchase History Pictures Front Microduino-Moisture Front Back Microduino-Moisture Back