“Microduino GPS recorder-306KIT”的版本间的差异
（→Bill of Materials） |
（→Debug） |
||
| 第43行： | 第43行： | ||
| | | | ||
==Debug== | ==Debug== | ||
| − | Step | + | Step 1：Build the hardware |
| − | Stack all the modules | + | Stack all the modules. Just put the GPS antenna outside, or it can not receive the signal. |
|- | |- | ||
| 第53行： | 第53行： | ||
|- | |- | ||
| | | | ||
| − | Step 2：Download program | + | Step 2：Download the program |
| − | If | + | If wanting to keep the default jumper (RX0、TX1), you need to unplug the Microduino NEO-6M during the download； |
| − | Step | + | Step 3：Debug |
| − | Find an open area to | + | Find an open area to debug for better signal. |
| − | The current status of the module can be judged by the PPS indicator: lighting, indicates that the module has started to work, but hasn't achieved position | + | The current status of the module can be judged by the PPS indicator: lighting, indicates that the module has started to work, but hasn't achieved position information. Flashing (100ms off, 900ms bright), means that the module has been successfully positioned. |
|- | |- | ||
| | | | ||
| + | |||
==Result== | ==Result== | ||
After get the position information, the parameters can be seen, and these data can be recorded into the memory card. | After get the position information, the parameters can be seen, and these data can be recorded into the memory card. | ||
2014年8月26日 (二) 07:14的版本
| Language | English |
|---|
OutlineProject：Microduino GPS Recorder Objective：Adopt the Microduino GPS module to acquire the geographic information and store it into Microduino-SD. Difficulty：Elementary Time-consuming：2 hours Maker：Microduino Studio-YLB | ||||||||||||||||||
Bill of Materials
| ||||||||||||||||||
|
文件:GPS-module.jpg 306KIT picture | ||||||||||||||||||
Document | ||||||||||||||||||
DebugStep 1：Build the hardware Stack all the modules. Just put the GPS antenna outside, or it can not receive the signal. | ||||||||||||||||||
|
文件:306KIT-1.jpg 306KIT 文件:306KIT-2.jpg 306KIT | ||||||||||||||||||
|
Step 2：Download the program If wanting to keep the default jumper (RX0、TX1), you need to unplug the Microduino NEO-6M during the download； Step 3：Debug Find an open area to debug for better signal. The current status of the module can be judged by the PPS indicator: lighting, indicates that the module has started to work, but hasn't achieved position information. Flashing (100ms off, 900ms bright), means that the module has been successfully positioned. | ||||||||||||||||||
ResultAfter get the position information, the parameters can be seen, and these data can be recorded into the memory card.
| ||||||||||||||||||
Note
Video |
