Lesson 8--Microduino "Pulse Recorder"

Objective Lesson showed how to use the button and aviod shaking issue. The solution is add a delay. But this solution has a disadvantage. Delay time according to the specific situation, because everyone is different to press the button. This lesson will introduce how to get the time to press a button, the program uses a pulse timing calculation. Besides that, you can learn how to use arduino's serial and monitor the data using serial. Equipment Microduino-Core Microduino-FT232R Other hardware equipment Breadboard Jumper one box Breadboard one piece Button one USB Data cable one Pulse Pulse is a process that a physical quantity quickly retun to its initial state after a short time mutation. In Microduino, pulse just a digital signal which changed between high and low in cyclical. Pulse timing is often used in the photoelectric encoder, Hall elements to calculate the speed. Experimental schematic Using the internal pull-up, external 104 ceramic capacitors for stabilization. Program int pin = 2; //Define Pin D2 float time1,time2; //Define variables to float void setup() { Serial.begin(115200); //Serial port baud rate pinMode(pin, INPUT_PULLUP); //Set pin to input mode with the internal pull-up } void loop() { //Read low pulse from the pin, the maximum pulse interval is 60 seconds, and assign the result to the variable time1 time1= pulseIn(pin, LOW,60000000)/1000;//Convert the time to ms Serial.print(time1); //Output the time1 by serial Serial.print("ms "); time2= pulseIn(pin, LOW,60000000)/1000.0;//Convert the time to ms Serial.print(time2); //Output the time1 by serial Serial.println("ms");//Through the serial port to print out the unit and wrap to a new line to output the next value. } } Serial monitoring Open the serial port monitor Click the Serial Monitor button, pop-up the serial monitor interface. Note： In order to using serial, you need add sentence "Serial.begin(xxxx)" in function setup()，xxxx is the baud rate; The baud rate should be same when using the serial monitor. The baud rate is a measure of the signal transmission rate. The baud rate is not a good match, it is easy garbled. When convert the unit, need pat attention to the data type： PulseIn（）function Function：read a pulse(HIGH or LOW) from a pin. Such as, if the value is HIGHT, pulseIn() will start timer when pin is HIGH, then stop the timer after pin change to LOW. The return value is the pulse time, unit is us. The timer range is 10us ~ 3mins. (1s=1000ms=1000000us) Grammar： pulseIn(pin, value) pulseIn(pin, value, timeout) Parameters： pin: pulse timing I/O port（int） value:pulse type,HIGH or LOW（int） timeout (optional)：Wait timer for pulse timing，unit is us, the default value is 1s.（unsigned long） Result For stabilization，add a 104 ceramic capacitors in signal change port, you can see a better result. Video