查看“Microduino-Relay”的源代码

{{Language|Microduino-Relay }}
{| style="width: 800px;"
|-
|
[[File: Microduino-Relay.jpg|400px|thumb|right| Microduino-Relay]]

Microduino-Relay is a relay module. It can be used in isolation control. 











==Features==
*Used in isolation control of high voltage and high current signal.  

==Specification==
*Input 5V operation voltage for primary side; 
*Output 10A 250VAC/10A 30VDC for secondary side; 
*1.27mm-pitch 4PIN interface; 
*Pin description: GND, VCC, signal input and NC(empty). Since the input signal is simulated, it needs to be driven by digital interface(D0~D13), which can be connected the pins (3~10) of Sensorhub with the corresponding pins(D0,D2,D4,D6,D8,D10,D12).  
[[file:mCookie-sensorhub_rule.JPG|thumb|800px|center]]

[[File: Microduino-Relay_rule1.jpg|600px|thumb|center]]

==Document==

*Schematic: '''[[File: Microduino_Relay.Zip]]'''

==Development==
You can use Microduino-Relay to convert weak signal into high voltage, high current signal or for isolation control.  

==Application==
*All hardware needed: [[Microduino-CoreUSB]], [[Microduino-USBTTL]], [[Microduino-Sensorhub]], dupont lines and USB cable. 
*Software: 
**Make sure you build Microduino IDE. If not, please refer to: [[Microduino Getting start]]
*Stack all modules and connect the Relay module to D2 port of Sensorhub with a wire.  
*Open Arduino IDE, select File→Examples→Digital→BlinkWithoutDelay program examples, choose the right board from Tools→Board and then compile.
*Select the right port from Tools→Serial Port in Arduino IDE after compiling, then download program. 
*After download, you'll see STA light on the Relay module blinks one time each second.  By measuring 2PIN crimping terminal on the Relay module with a multimeter, you can see that 2PIN crimping terminal also powers on and off each second. 

==Purchase==

==History==

==Pictures==

*Front 
[[file: Microduino-Relay-F.JPG|thumb|600px|center|Microduino-Relay Front]]
*Back 
[[file: Microduino-Relay -b.JPG|thumb|600px|center|Microduino-Relay Back]]
|}