“Maple Lesson 01 - Blinking LED”的版本间的差异

来自Microduino Wikipedia
跳转至: 导航搜索
(Created page with "{| style="width: 800px;" |- | == Objective == Using Microduino-CoreSTM32 to control the on-board LED. Actually you can learn to how to use the Micrduino-CoreSTM32's I/O port. ...")
(没有差异)

2014年7月15日 (二) 00:31的版本

Objective

Using Microduino-CoreSTM32 to control the on-board LED. Actually you can learn to how to use the Micrduino-CoreSTM32's I/O port. This is a basic skill you should master and for further study.

Prerequisites

Equipment

Microduino-CoreSTM32 is a 32-bit ARM Cortex-M3 development board, based on STMicroelectronics' STM32F103CBT6.

  • Other hardware equipment
    • USB Data cable 1(one) piece

Program

  • Using delay() function:
int led = 13;// Define the PIN
void setup() {                
  pinMode(led, OUTPUT);  // Define the I/O port 13 as output   
}
void loop() {
digitalWrite(led, HIGH); //I/O port 13 output High. If the connection is high lighted,the LED will light, otherwise extinguished
delay(1000);               // delay 1s
digitalWrite(led, LOW); //I/O port 13 output Low.If the connection is high lighted,the LED off, otherwise light.
delay(1000);               // delay 1s
}
  • Using function millis():Return the number of milliseconds from start running Microduino program to now.
int ledPin=13;
#define TIME 1000 
long time1=0,time2=0;
void setup()
{
  pinMode(ledPin,OUTPUT);
}
void loop()
{
if(millis()<time2+TIME)
{
digitalWrite(ledPin,HIGH);
time1=millis();
}
else 
{
digitalWrite(ledPin,LOW);
if(millis()>time1+TIME)
time2=millis();
}
}

Using function millis () is better than the delay () function, less resource and fewer delays on the system.

Download program method

  • Choose the board type in "tools", the "Microduino-CoreSTM32 to Flash" if you want to run the program after reset the board, or "Microduino-CoreSTM32 to RAM" if you just want to test it for one time.
  • Compile downloads
Compile.jpg
Download.jpg

Result

After the download, you can see LED flashes once every 1s.

Video