Lesson 6--Microduino "Breathing Light"

Language	English

Objective In the last two lessons we used external devices (a button and a potentiometer) to generate PWM to control the LED. From Lesson 1, we also learned how to turned an LED on and off using software. But how would we go about controlling an LED's brightness through PWM using software only? This lesson will teach you how to implement an LED "Breathing Light". Equipment Microduino-Core Microduino-FT232R Other hardware equipment 1x Box of breadboard jumper wires 1x Breadboard 1x LED 1x 220Ω resistor 1x USB Data cable Experiment Schematic The schematic above uses a high level connection. Since we want the LED to be more than just on and off, we still need to connect the anode to a Microduino PWM I/O port. Using a low level connection achieves the same result. Program int ledPin=11;//D3、D5、D6、D9、D10、D11 is Microduino PWM I/O output port void setup() { pinMode(ledPin,OUTPUT); } void loop() { for(int fadeValue=0;fadeValue<=255;fadeValue+=5) //Increase PWM value, control the LED brightness by adjusting the value of fadeValue. { analogWrite(ledPin,fadeValue); //Write the brightness value to LED. delay(30); //Keep the current brightness 30ms. } for(int fadeValue=255;fadeValue>=0;fadeValue-=5) //Decrease PWM value,control the LED brightness by adjusting the value of fadeValue. { analogWrite(ledPin,fadeValue); //Write the brightness value to LED. delay(30); //Keep the current brightness 30ms. } } This program uses for loops, which allows for convenient control of the brightness of the LEDs. Result LED gradually goes from off to on, then off. It then repeats. Video http://v.youku.com/v_show/id_XNzA5OTk3MTU2.html