Lesson 15--Microduino "Make a circuit of temperature-sensitive cup "

来自Microduino Wikipedia
跳转至： 导航、 搜索
Language English

Objective

This lesson will show you how to make an analog temperature-sensitive cup combined with Microduino.

Equipment

  • Microduino-Core
  • Microduino-FT232R
  • Other hardware equipment
    • Breadboard Jumper one box
    • Breadboard one piece
    • LM35D temperature sensor one
    • RGB LED one
    • 450Ω resistor one

Experimental schematic

Lesson15-schematic.jpg

LM35's connection doesn't change, just add a common anode RGB LED.

Program

void setup() {
  Serial.begin(115200);         //Set hte baud rate as 115200
  for(int i=2;i<5;i++)          //Set LED output
  {
    pinMode(i, OUTPUT);  
  }
}

void loop() {

  int n = analogRead(A0);    //Read voltage value from A0 port

  float temp = n * (5.0 / 1023.0*100);   //Use a float variable to save temperature value which was calculated from voltage.

  if (temp<21)  //Low temperature setting, and led display
  {
    digitalWrite(4, HIGH);
    digitalWrite(3, HIGH);
    digitalWrite(2, LOW);
  }
  else if (temp>=21 && temp<=23)  //Middle temperature setting, && means "and" operation
  {
    digitalWrite(4, HIGH);
    digitalWrite(3, LOW);
    digitalWrite(2, HIGH);
  }
  else if (temp>23)   //High temperature setting
  {
    digitalWrite(4, LOW);
    digitalWrite(3, HIGH);
    digitalWrite(2, HIGH);
  }
  Serial.println(temp); //Output the temperature from serial port
  delay(1000);         //Wait for 1s and refresh the data
}

Result

The temperature is set to low temperature, middle temperature and high temperature three range. When the temperature in the low temperature zone, RGB display a green light, blue light display in the middle temperature zone,and high temperature red light. Simulates a temperature sensing cup.

Video

https://www.youtube.com/watch?v=Xb-FXhw_Bx4

取自“http:///https//wiki.microduino.cn/index.php?title=Lesson_15--Microduino_%22Make_a_circuit_of_temperature-sensitive_cup_%22&oldid=8188”