Jasonsheng：Created page with "{{Language | Microduino 光照强度上传Yeeklink(TSL2561)}} {| style="width: 800px;" |- | ==Objective== This tutorial will teach you update the light intensity's data to yee..."

2014-04-16T13:57:10Z

Created page with "{{Language | Microduino 光照强度上传Yeeklink(TSL2561)}} {| style="width: 800px;" |- | ==Objective== This tutorial will teach you update the light intensity's data to yee..."

新页面

{{Language | Microduino 光照强度上传Yeeklink(TSL2561)}}
{| style="width: 800px;"
|-
|
==Objective==
This tutorial will teach you update the light intensity's data to yeelink, using the light intensity sensor TSL2561.

==Equipment==
*'''[[Microduino-Core]]'''
*'''[[Microduino-FT232R]]'''
*'''[[Microduino-Weatherstation]]'''
*'''[[Microduino-RJ45]]'''
*'''[[Microduino-ENC28J60]]'''
*Other equipment
**USB cable
**Ethernet cable

==Experiment==

==Schematic==
[[File:Microduino光照强度上传到Yeelink(TSL2561)原理图.jpg|600px|center|thumb]]

*Microduino-RJ45
*Microduino-ENC28J60
*Microduino-Core
*Microduino-FT232R
*Microduino-Weatherstation

Stack all of them, and then connect the ethernet cable.

==Program==

Refers to yeelink_TSL2561

==Debug==

Step 1：Set up hardware, as follows:
[[File:Microduino光照强度上传到Yeelink(TSL2561)连接图.jpg|600px|center|thumb]]

Step 2：Add a sensor, one device can add more sensors, click [+ add a sensor] in [Device management], then you can see following picture:
[[File:yeelink添加光照传感器.jpg|600px|center|thumb]]

At this point, you can see the data curve in [Device management], URL's address:
http://api.yeelink.net/v1.0/device/4444/sensor/77777datapoints

The number behind "Device" is your device ID, the number behind "sensor" is your sensor ID, every user has different ID.

Step 3：Modify the API KEY, deviceID and sensorID to your own ID in code, and copy to IDE.

Step 4：Make up connection and run program.

Step 5：Then you can see the IP address and data information in serial monitor window, as following picture:
[[File:连接到yeelink串口显示信息(TSL2561).jpg|600px|center|thumb]]

At last, you can check the data in yeelink.

==Result==

In device management, your light intensity sensor will be show as following. If there is a value, that means successed.
[[File:yeelink光照传感器数据(TSL2561).jpg|600px|center|thumb]]

==Video==

http://v.youku.com/v_show/id_XNjk4NDMxNDg0.html

|}

Microduino Update light intensity to Yeeklink(TSL2561) - 版本历史

Jasonsheng：Created page with "{{Language | Microduino 光照强度上传Yeeklink(TSL2561)}} {| style="width: 800px;" |- | ==Objective== This tutorial will teach you update the light intensity's data to yee..."