1304410487@qq.com：/* Equipment */

2015-10-29T07:04:22Z

‎Equipment

1304410487@qq.com：Created page with "{| style="width: 800px;" |- | ==Outline== Microduino-IR-Transmitter can emit infrared signal through LED and then receive signal with Infrared Receiver. Like a remote cont..."

2015-10-29T06:57:09Z

Created page with "{| style="width: 800px;" |- | ==Outline== Microduino-IR-Transmitter can emit infrared signal through LED and then receive signal with Infrared Receiver. Like a remote cont..."

新页面

{| style="width: 800px;"
|-
|
==Outline==
Microduino-IR-Transmitter can emit infrared signal through LED and then receive signal with [[Infrared Receiver]]. Like a remote controller, the infrared transmitter can also control home appliances such as TV, air conditioner, water heater and refrigerator. Its maximum transmission distance is 10m.

==Specification==
*Electrical specification
**Operation voltage: 3.3V~5V
*Tech parameters
**Sensing distance:10m
*Size
**Size of the LED: 5mm，
** 10mm*20mm
**1.27mm-pitch 4PIN interface
*Connection Method
**GND, VCC, D6,NC. Modules must adopt D6 interface.
==Development==
===Equipment===
{|class="wikitable"
|-
|Module||Number||Function
|-
|[[mCookie-CoreUSB]]||1||Core board
|-
|[[mCookie-Hub]]||1||Sensor pin board
|-
|[[Microduino-IR transmitter]]||1||Infrared transmission
|}

[[File:IR transmitter-module.jpg|center|600px]]
===Preparation===
Setup 1：Connect the IR transmitter's interface with the Hub's D6 digital port.
[[file:mCookie-IR transmitter-sensor.JPG|600px|center]]
*Setup 2：Connect the core, Hub and IR transmitter to a computer with a USB cable.
[[file:mCookie-strandtext-pc.JPG|600px|center]]
===Debugging===
*Open " IRsendDemo " program in the libraries.

[[file:mCookie-IRsendDemo.JPG|thumb|800px|center]]
* Select the right board and COM port, compile and download. You can refer to [[AVR Core：Getting started]]
[[file:upload.JPG|thumb|800px|center]]
*include <IRremote.h> Use infrared library function
*IRsend irsend; Define infrared receiving object
*irsend.sendSony(0xa90, 12); Send infrared code
* You can open the serial monitor. Input any values at the console and you'll see the LED on the IR-transmitter blinks once, meaning the infrared signal has been sent.

@@ 第26行： / 第26行： @@
 |[[mCookie-Hub]]||1||Sensor pin board
 |-
-|[[Microduino-IR transmitter]]||1||Infrared transmission
+|[[Microduino-IR Transmitter]]||1||Infrared transmission
 |}
 [[File:IR transmitter-module.jpg|center|600px]]
 ===Preparation===
 Setup 1：Connect the IR transmitter's interface with the Hub's D6 digital port.

Infrared transmission - 版本历史

1304410487@qq.com：/* Equipment */

1304410487@qq.com：Created page with "{| style="width: 800px;" |- | ==Outline== Microduino-IR-Transmitter can emit infrared signal through LED and then receive signal with Infrared Receiver. Like a remote cont..."